Troubleshooting - Ryobi RY40806 Manuel D'utilisation

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Handle not in position.
Snow blower not starting.
The motor is on but the impeller does
not turn.
After passing, the snow blower leaves
a layer of snow on the ground.
This product has a Five-year Limited Warranty for personal, family,
or household use (90 days for business or commercial use).
For warranty details, visit www.ryobitools.com

TROUBLESHOOTING

POSSIBLE CAUSE
Handle adjustment knobs and/or handle
lock levers are not secured.
Battery is low in charge.
Start button is not depressed.
The drive belt is worn or broken.
The scraper is worn.
The impeller mechanism is worn.
MAKE THE MOST OF YOUR PURCHASE!
Go to http://register.ryobitools.com and register your new tool on-line.
Your product has been fully tested prior to shipment
to ensure your complete satisfaction.
For any questions about operating or maintaining
your product, call the RYOBI Help Line!
or call (toll free) 1-800-860-4050.
12 — English
SOLUTION
Make sure handle adjust knobs are fully
seated and handle lock levers are fully
closed.
Charge the battery.
Press start button.
Have the drive belt replaced by an
authorized service center.
Replace the scraper. See Replacing the
Scraper in the Maintenance section.
Have the impeller mechanism replaced
by an authorized service center.