Troubleshooting - Ryobi RY42110 Manuel D'utilisation

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORIZED SERVICING DEALER.
PROBLEM
Motor won't start
Material is not sucked in properly (re-
duced vacuuming power)

TROUBLESHOOTING

CAUSE
Lower tube hasn't been telescoped
out to its full length
No power (power failure)
Connection lead wire defect
Motor or switch defect
Machine is clogged or blocked
Vacuum bag too full
Speed setting too low
12 - English
REMEDY
Pull the lower tube out to its full
length.
Check circuit breaker.
Check fuse
Check circuit breaker.
Replace lead or have lead checked
(electrician); never use defective lead.
Contact the authorized service center.
Clean tool
Empty bag
Adjust to higher speed