Maintenance; Cleaning - ETNA AB790RVS Mode D'emploi

MAINTENANCE

Cleaning

EN 8
Attention! Before carrying out maintenance work, always disconnect
the cooker hood from the power supply by pulling out the plug or
switching off the power at the fuse box. The hood must be cleaned
regularly, both inside as well as outside (with at least the same regularity
as used for cleaning the grease filters). Do not use any products that
contain abrasive materials. Do not clean with alcohol!
Attention! If you do not follow these instructions with regards to the
cleaning of the appliance and the cleaning or replacement of the filters,
this can lead to fire. It is essential to follow these instructions!
The manufacturer is not liable for damage to the motor or damage as a
result of fire that is due to improper servicing or not following the above
safety requirements.
Cooker hood
Clean the cooker hood with soapy water and a soft cloth. Then treat
with clean water. Do not use any aggressive cleaning agents such as
soda. The lacquer of the cooker hood will remain in good condition if
you rub the lacquer with wax once in a while.
Stainless steel hoods
Do not use scouring sponges or other abrasives on stainless steel
hoods. Finish with a non-abrasive, non-polishing agent and scrub in the
direction of the brushing of the stainless steel.
Metal grease filters
Metal filters need to be cleaned once per month (or when indicated by
the filter cleaning indicator if present on the model) with neutral cleaning
agents, by hand or in the dishwasher at low temperatures using a
short programme. Place the grease filters in the dishwasher with the
openings facing down so that water can run out. Aluminium grease
filters will become dull from the cleaning agents in the dishwasher.
This is normal and does not affect the functioning of the filters.