Husqvarna FS5000 D Manuel D'utilisation page 5

Overview of the controls and the control panel
6
5
4
3
1. Lever for speed control. Forward, rearward and
transmission stop *
2. Switch for cutting depth adjustment *
3. Lever for the water cooling system for the cutting
blade *
4. Knob for adjustment of the blade lowering speed *
5. Engine start switch
6. Machine stop button *
7. Engine start position *
8. Ignition on position *
9. Engine stop position *
10. Button to show blade speed in rpm on the display *
11. Button to show engine speed in rpm on the display *
12. Knob for the throttle control
13. Menu button *
14. Knob for adjustment of the blade depth stop *
15. Reset button for the blade depth stop *
16. E-track reset button * (optional)
17. Selection button
Symbols on the product on page 5 .
* = Refer also to
Symbols on the product
WARNING: This product can be dangerous
and cause serious injury or death to the
operator or others. Be careful and use the
product correctly.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
1143 - 002 - 08.07.2019
6
1
2
7
9
10
8
4
3
17 17
16
17
17
17
17
11 12
14
13
Use hearing protection, eye protection and
respiratory protection. Refer to
protective equipment on page 10 .
All displacement of the machine outside the
cutting area shall be carried out with the tool
not in rotation.
Remove the cutting blade before
transportation and before you lift the
product, to prevent damage to the cutting
blade.
The blade guards must always be installed
on the product. Do not let more than 180° of
the cutting blade show.
Make sure that the cutting blade is not blunt
or has damages, such as cracks.
Make sure that the cutting blade is
applicable to the same speed or a higher
speed than the value given on the product
type plate. A cutting blade that is operated at
too high speed can break and cause injury
or damage.
Do not use the product near flammable
material or gases.
15
2
1
Personal
5