Husqvarna FS5000 D Manuel D'utilisation page 15

To install a cutting blade
Product configuration for different
Read the section
blade dimensions on page 17 before you install a
cutting blade.
1. Set the engine start switch to ignition on position (A).
A
2. Push the switch for cutting depth adjustment up to lift
the cutting blade.
3. Set the engine start switch to stop position (B).
4. Push the machine stop button on the control panel.
5. Close the water valve.
1143 - 002 - 08.07.2019
6. Loosen the front bolt on the blade guard and lift the
blade guard latch (A).
C
B
7. Lift the blade guard front (B) and lock the blade
guard in upright position with a wire and carabiner
(C).
8. Remove the blade shaft bolt (A).
A
Note: The blade shaft bolt on the right side of the
product has a left thread. The blade shaft bolt on the
left side of the product has a right thread.
9. Remove the outer blade flange and the flat washer
(B).
10. Examine the blade shaft bolt, the blade flanges, the
flat washer and the blade flange arbor (C) for
damages. Replace worn or damaged parts.
11. Clean the contact surfaces of the cutting blade and
the blade flanges.
12. Put the cutting blade on the outer flange arbor.
13. Install the cutting blade and the outer flange into the
inner flange. Make sure that the locking pin (D) goes
through the blade and into the inner flange.
A
B C
D
B
15