Numark C2 Guide D'utilisation Rapide page 3

INTRODUCTION
Welcome to the C2 – a professional 19", 4-channel mixer. Here are some of the features that you will come
to love about this device:
8 line, 3 phono, & 2 mic inputs
Fader-start crossfader with front panel controls
Split/blend cue options
Panning on master fader with stereo/mono switch
5-band ±6/±12dB EQ with rear panel defeat
Master balanced XLR outputs with stereo/mono controls
Cues on each channel with cue/send rear output for sampling and booth cue monitor
Channel gain control with PFL meter
Neutrik™ "Combo" connector (1/4" or XLR plug) for DJ mic
Auto-talkover mic input with bass and treble
Tape out for direct recording
Front panel BNC light connector
Zone output
We hope that the C2 serves you well for many years to come.
Sincerely,
The People of Numark
BOX CONTENTS
C2
IEC Power Cable
Quickstart Guide
Safety & Warranty Information Booklet
REGISTRATION
Please go to http://www.numark.com to register your C2. Registering your product ensures that we can keep
you up-to-date with any last-minute product developments and provide you with world-class technical
support, should you run into any problems.
GROUND RULES
1. Make sure all items listed in the BOX CONTENTS section are included in the box.
2. READ SAFETY & WARRANTY INFORMATION BOOKLET BEFORE USING THE PRODUCT.
3. Study the connection diagram in this guide.
4. Place mixer in an appropriate position for operation.
5. Make sure all devices are turned off and all faders and gain knobs are set to "zero."
6. Connect all stereo input sources as indicated in the diagram.
7. Connect the stereo outputs to power amplifier(s), tape decks, and/or other audio sources.
8. Plug all devices into AC power.
9. Switch everything on in the following order:
•
Audio input sources (i.e. turntables, CD players, etc.)
•
Mixer
•
Last, any amplifiers or output devices
10. When turning off, always reverse this operation by turning off:
•
Amplifiers
•
Mixer
•
Last, any input devices
3