Cembre B1300-C Notice D'utilisation Et Entretien page 12

4.4) ERRORS:
these appear during operation, combined with a beep and flashing
LED Worklights, to notify the operator of procedural or operational errors.
Message Error description
The pressure release button (2)
was pressed before the control
ERROR
parameters were reached (Force/
Pressure).
Abnormal power consumption
of the motor for more than 3
001
seconds.
The tool stops.
002
Output voltage of the pressure
transmitter is out of the pre-set
002
range.
Failure to reach the set pressure
003
within 30 seconds of continuous
003
operation of the machine.
Overcharging of the battery with
004
protection tripping.
004
The tool stops.
Errors are displayed for about 30 seconds before being reset, but will display repeatedly in
the event of permanent anomalies.
– Following information applies in member states of the European Union:
USER INFORMATION in accordance with "Directives 2002/95/EC and 2002/96/EC.
The 'Not in the bin' symbol above when shown on equipment or packaging means that the
equipment must, at the end of its life, be disposed of separately from other waste.
The separate waste collection of such equipment is organised and managed by the manufacturer.
Users wishing to dispose of such equipment must contact the manufacturer and follow the prescri-
bed guidelines for its separate collection. Appropriate waste separation, collection, environmentally
compatible treatment and disposal is intended to reduce harmful environmental e ects and pro-
mote the reuse and recycling of materials contained in the equipment. Unlawful disposal of such
equipment will be subject to the application of administrative sanctions provided by current legi-
slation.
Solution
Repeat the work cycle and wait for the
motor to stop automatically.
Wait for the display to turn o (60 sec.)
or remove and re-insert the battery,
then re-start the tool.
If the error occurs frequently, contact
Cembre.
Repeat the work cycle; if the error
occurs frequently, contact Cembre.
Repeat the work cycle; if the error
occurs frequently, contact Cembre.
Wait for the display to turn o (60 sec.)
or remove and re-insert the battery,
then re-start the tool.
If the error occurs frequently, contact
Cembre.
12