Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. FUNCTIONING / MANIPULATION
a) Installation / assembly:
- Unpack carefully the device of its packaging.
- Place it on a plane and heatproof surface.
- Never place the device near a wall or near a partition makes of combustible ma-
terials even if it is very well isolated.
- A distance of minimum 10 cm with the partition or the wall is necessary.
- Remove the labels and protective film around the device. If needed you can use
a solvent
b) First starting:
First cleaning
During the first use, clean the grid, the enamelled drip tray and the spit in warm
soapy water.
Connect the heating element in the connecting box in the oven.
Warm your machine up for about 30min at 250°C. This may emit a slight smell for
a few moments.
Put the ladders on the inner side walls of the oven.
Slide the grids on the level wished.
Connection of the device
- Check that the tension and the frequency of the electricity network suit to the
values indicated on the descriptive plate.
- Check that neither the cord nor the plug are damaged. If necessary, it has to be
replaced by the manufacturer, its after sale service or any qualified person to
avoid any risk.
- Make sure that every control knob is positioned on 0.
- Unwind completely the electric power cable and connect it in a plug connected
with the earth.
- The device is connected.
NB: in case of connection of the device in a plug without earth protection or direct-
ly on the electricity network, confide its connection to a qualified person .
29
Publicité
Chapitres
Table des Matières
