Table des Matières
Publicité
6/. Reassemble the fireplace in reverse order from 3 through 2. / Remonter la cheminée dans l'ordre
inverse de 3 à 2.
7/. Turn on the gas. / Allumez le gaz.
CAUTION
ATTENTION
Aeration adjustment is important for the correct functioning of the appliance. Carbon build up, flame
lifting or any malfunction due to improper aeration adjustment during installation is not covered under
the factory warranty.
Réglage de l'aération est importante pour le fonctionnement correct de l'appareil. Une accumulation
de carbone, de levage flammes ou de toute défaillance due à une mauvaise aération d'ajustement
lors de l'installation n'est pas couvert par la garantie d'usine.
3.3.10 ALTITUDE ADJUSTMENT
Altitude
0 – 2000 ft (0 – 610 m)
2000 – 4000 ft (610 - 1219 m)
4000 – 6000 ft (1219 - 1829 m)
All valves have been pre-set and certified for installation at elevations from 0 – 2000 feet (0 – 610m)
above sea level.
When installing this unit at higher elevations, it is necessary to decrease the input rating by replacing
the existing burner orifice with a smaller size for installations over 2000 feet (610m). The appliances
input should be reduced 4% for each additional 1000 feet (305m) above sea level. For the USA, de-
rate the unit from sea level according to the gas installation code.
Air tube and Air shutter shown removed
for clarity purposes only.
PARTS REQUIRING ADJUSTMENT DURING OPERATION MAY BE HOT.
PIECES NECESSITANT REGLAGE PENDANT LA MARCHE PEUT ETRE CHAUDE
Natural Gas – 1/8" (3.175mm)
Propane – Fully Open
Set Screw
Factory Setting
Natural Gas – Orifice Size
44
45
46
Propane – Orifice Size
56
57
58
Page 37 of 60
Publicité
Table des Matières
