hergom E-20 N Instructions D'installation, D'utilisation Et D'entretien page 39

2.2.3 - CLEANING
Cleaning should always be performed when the stove is cold.
1.-Cleaning of the ashes
These stoves are equipped with an ash pan located below the base of the hearth.
To access it, open the ash pan door.
Remove the ash pan which is found in its interior and empty the ash.
Empty the ash pan into a metal container and remove it from the house immediately.
If necessary, clean the ash pan holder.
2.-Enamelled Parts
Preferably use a damp cloth.
Do not use strong detergents or abrasive products which may damage the surface.
3.- Painted Parts
Cleaning of these parts should be performed with a dry cloth to avoid oxidation.
2.2.4 – DOOR GLASS
a.- Cleaning
Glass cleaning agents for stoves are quite effective.
Never try to clean the glass while the stove is in operation.
We recommend the use of HERGÓM glass cleaning agent for its proven effectiveness.
If the glass of your stove door is constantly covered with soot, the flame is "poor" and the
connector and the chimney are being obstructed with soot and creosote.
b.- Replacement
The glass of your stove is especially manufactured for wood stoves. In the event of breakage,
it should be replaced by glass of the same characteristics. Contact our Supplier to obtain the
appropriate glass, together with the installation instructions and gaskets.
2.2.5 - CONNECTOR AND CHIMNEY
Read the chapter corresponding to this area in the Installer's Manual. (Chapter 1.3)
39