Grizzly GP 3032 Inox Traduction De La Notice D'utilisation Originale page 16

GB
initial operation, have a specialist
check that the required electrical pro-
tection measures are in place.
• Do not carry or fix the equipment by
the cable or pressure line.
• Protect the equipment from frost and
from running dry.
• Use only original accessories and do
not carry out conversion work on the
equipment.
• Please read the notes in the operating
instructions on the topic of "mainte-
nance and cleaning". Any measures
above and beyond these, particularly
opening the equipment, are to be car-
ried out by an electrician. In the case
of repairs, always contact our service
centre.
Electrical safety:
Caution: to avoid accidents and
injuries from electric shocks:
• After erection, the mains plug must be
freely accessible when the equipment
is in operation.
• Before operating your new pump,
have a specialist check:
- The earthing, the protective mul-
tiple earthing; the residual current
circuit breaking must be compliant
with the safety regulations of the
energy supply company and func-
tion without fault,
- The protection of the electrical plug
connections from the wet.
- If there is a risk of flooding, fix the
plug connections in an area that is
safe from flooding.
• Ensure that the mains voltage match-
es the specifications on the rating
plate.
16
• The electrical installation shall be ac-
cording to national wiring rules.
• Connect the equipment only to a
socket with a residual current protec-
tion device (residual current circuit
breaker) with a rated current of not
more than 30 mA; minimum fuse
10 amperes.
• Before each use, check the equip-
ment, cable and plug for damage. De-
fective cables are not to be repaired,
but rather replaced by new ones.
Have any damage to your equipment
repaired by a specialist.
• If the power cable for this equipment
is damaged, it must be replaced by
the manufacturer, a customer service
agent of the same or a similarly quali-
fied person in order to prevent haz-
ards.
• Do not pull the plug from the socket
by the cable. Protect the cable from
heat, oil and sharp edges.
• Do not carry or fix the equipment by
the cable.
• Use only extension cables that are
protected from spray water and de-
signed for outdoor use. Always fully
unroll a cable drum before use. Check
the cable for damage.
• Before any work on the equipment,
during work breaks and in the case
of non-use, remove the plug from the
socket.
• Mains connection cables must not
have a cross-section that is smaller
than those of rubber hoses with the
designation H07RN-F.