Accessories - RedMax GZ5000 Manuel D'utilisation

Fuel and lubrication system
Fuel tank capacity, US Pint/liter
Oil tank capacity, US Pint/liter
Type of oil pump
Weight
Weight, lb/kg
Saw chain/guide bar
Type of drive sprocket/number of teeth
Saw chain speed at 133% of maximum engine power
speed, ft/s / m/s.
Recommended cutting equipment
A specific chainsaw model has to be evaluated with the
cutting equipment to be recommended and fulfill the
requirements in ANSI B175.1-2012 (Internal Combustion
Engine-Powered Hand-Held Chainsaws - Safety and
Environmental Requirements) and Canadian Standards
CSA Z62.1-15 (Chainsaws) and CSA Z62.3-11 (R2016)
(Chainsaw kickback).
Chainsaw model RedMax GZ5000 meet the safety
requirements in ANSI B175.1-2012 and Canadian
Standards Association CSA Z62.1-15 (Chainsaws) and
CSA Z62.3-11 (R2016) (Chainsaw kickback), when
equipped with the below listed saw chain and guide bar
combination(s).
Note: Other chainsaw models may not meet the
kickback requirements when equipped with the listed
guide bar and saw chain combinations.
Guide bar
Length, in / Pitch, in
cm
16/41 0.325
16/41
18/46
18/46
Filing equipment and filing angles
Use a RedMax file gauge to sharpen the saw chain. A
RedMax file gauge makes sure that you get the correct
1519 - 002 - 08.07.2020

Accessories

Gauge, in / Max. nose ra-
mm dius
0.058 / 1.5 10T
0.050 / 1.3
RedMax GZ5000
0.94 / 0.52
0.57 / 0.27
Adjustable
11 / 5.0
Rim / 7
80.7 / 24.6
We recommend only to use the listed guide bar and saw
chain combinations.
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in
ANSI B175.1-2012.
Kickback and guide bar nose radius
For guide bars with a sprocket nose the nose radius is
specified by the number of teeth, such as 10T. For solid
guide bars the nose radius is specified by the dimension
of the nose radius. For a given guide bar length, you can
use a guide bar with smaller nose radius than given.
Saw chain
Type
RedMax H25
RedMax H30
filing angles. The part numbers are given in the table
below.
Length, drive Low kickback
links (no.)
66 Yes
72
66
72
33