not correctly lubricated, the risk of wear on the guide
bar, saw chain and chain drive sprocket increases.
Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
To assemble the guide bar and saw
chain
1. Move the front hand guard rearward to disengage
the chain brake.
2. Remove the bar nut and the clutch cover.
3. Assemble the guide bar onto the bar bolt. Move the
guide bar to its most rear position.
4. Install the saw chain correctly around the drive
sprocket and put it in the groove on the guide bar.
823 - 011 - 24.06.2020
Assembly
5. Align the hole in the guide bar with the chain adjuster
pin and install the clutch cover.
6. Tighten the bar nuts finger tight.
7. Tighten the saw chain. Refer to
of the saw chain on page 30 for instructions.
8. Tighten the bar nut.
Note: If the clutch cover is not easy to remove,
tighten the bar nut, engage the chain brake and
release. A click is heard if it is released correctly.
WARNING: Always use protective
gloves when you assemble the saw
chain.
To adjust the tension
9