Husqvarna 439 Manuel D'utilisation page 3

Masquer les pouces Voir aussi pour 439:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1. Chain brake and front hand guard
2. Felling direction mark
3. Air purge bulb
4. Air filter cover
5. Choke control
6. Rear handle
7. Information and warning decal
8. Start/stop switch
9. Fuel tank
10. Adjuster screws carburetor
11. Starter rope handle
12. Starter housing
13. Chain oil tank
14. Right hand guard
15. Spark plug cap/spark plug
16. Muffler
17. Oil pump adjustment screw
18. Chain catcher
19. Throttle trigger lockout
20. Front handle
21. Saw chain
22. Bar tip sprocket
23. Guide bar
24. Spiked bumper
25. Chain tensioning screw
26. Product and serial number plate
27. Clutch cover
28. Throttle trigger
29. Transportation guard
30. Combination wrench
31. Box spanner
32. Operator's manual
33. Brake band
34. Air filter
35. Vibration damping system, 3 units
Symbols on the product
Be careful and use the product correctly.
This product can cause serious injury or
death to the operator or others.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Always wear approved protective helmet,
approved hearing protection and eye
protection.
Use 2 hands to operate the product.
823 - 011 - 24.06.2020
Do not operate the product with one hand
only.
Do not let the guide bar tip touch an object.
Warning! Kickback can occur when the
guide bar tip touches an object. A kickback
causes a lightning fast reverse reaction that
throws the guide bar up and in the direction
of the operator. Can cause serious injury.
Chain brake, engaged (right). Chain brake,
disengaged (left).
Choke level in "open position".
Choke level in "closed position".
Air purge.
Adjustment of the oil pump.
Fuel.
Chain oil.
yyyywwxxxx
Husqvarna H37
Max 9T
XX
Computed kickback bar stopping angle
without actuated chainbrake, CKA wob.
The rating plate shows se-
rial number. yyyy is the
production year and ww is
the production week.
Recommended cutting
equipment in this exam-
ple: Guide bar length 14
in, maximum nose radius
9 Teeth and chain type
Husqvarna H37.
3

Publicité

Table des Matières
loading

Table des Matières