HumanTechnik sonumaxx BT Mode D'emploi page 26

Interference:
- The receiver battery may be low. Recharge the receiver.
- The distance between transmitter and receiver may be to large. Decrease the distance.
- The audio input signal may be too low. Raise the volume of the audio source.
Follow the following instructions if the receiver cannot be linked to the transmitter:
1. Unplug the transmitter from the power supply.
2. Turn the receiver on.
3. Plug the transmitter back into the power supply.
4. Press the telephone button on the receiver until the blue LED on the receiver flashes
quickly.
5. Press the Pair button on the transmitter.
6. The transmitter and receiver will pair; once the two blue LEDs are constantly lit, the
connection has been made.
Specifications:
Dimensions of transmitter:
Dimensions of receiver housing:
Dimensions of stethoset receiver:
Transmitter:
Power feed:
Power supply:
Power adapter supply:
Weight:
Modulation type:
Carrier frequency:
Transmission output:
Range:
Frequency response:
Distortion factor:
Signal-to-noise ratio:
Temperature working range:
Receiver:
Run time per full charge:
Charging time:
Rechargeable battery (integrated):
Maximum volume:
Weight of stethoset receiver:
Weight of loop receiver:
26 English
H 42 mm x W 108 mm x D 108 mm
Ø 65 mm x D 28 mm
H 233 mm x W 122 mm x D 28 mm
approx. 4 VA
5 Volt DC
100-240 Volt 50-60 Hz
110 g
Stereo
2.4 GHz
10 mW
approx. 15 meters
30 - 20000 Hz
< 1 %
> 70 dB
0° C – 55° C
approx. 7 h
approx. 3 h (2h for 90% charge)
3.7 V lithium polymer
125 dB
66 g
80 g