Special Active Source Selection Mode And Setting Adjustments - Ecler CA120HZ Notice D'utilisation

4.2. Special active source selection mode and setting adjustments

Use the knob on the front panel to access special modes for selecting active sources and adjusting
levels and equalization (bass and treble). You can access these modes by holding in the knob for a certain
time and then turning it. By adjusting the level of each source you can mix the signal from the microphone
or line (LINE3/MIC) and another line (LINE1 or LINE2), and the result of this mix will be controlled by the
general output volume of the unit together, in other words, respecting the relative levels set of each source.
The full procedure for accessing and operating in these special modes and the options available in
each are set out in the following graph:
Notes:
1. If the device is in special mode for 10 seconds and the front knob is not touched, the equipment
automatically reverts to VOL/MUTE mode.
2. In tone control mode, when you turn the knob in either direction it flashes fast while the gain of
the affected tone increases. When either end of the scale is reached (-10 ó +10dB) or when it
goes through the centre point (0dB) it flashes more slowly.
8