Table des Matières
Publicité
THREADING THE BOBBIN THREAD
1. Raise the needle to its highest position by rotating the hand
wheel toward you (counter-clockwise).
2. Remove the bobbin cover plate by pushing the release
button to the right. Bobbin cover will pop up sufficiently to
allow you to remove the cover.
3. Insert the bobbin making sure the bobbin rotates counter-
clockwise when you pull the thread.
NOTE: This is a very important step as the bobbin
can become unthreaded and cause sewing problems
if it rotates clockwise.
4. Pull thread through the slot (A) and then to the left.
5. With a finger held gently on top of the bobbin, pull the
thread until it stops in slot (B). Then pull about 6" (15 cm)
of thread and lead it towards back of the machine under
the presser foot.
NOTE: This is also a very important step to assure
the bobbin thread does not slip out of position.
6. Replace the bobbin cover plate onto the needle plate.
18
1
2
3
4
A
5
B
6
A
Publicité
Table des Matières
