Table des Matières
Publicité
SETTING UP YOUR MACHINE
Be sure to wipe off any excess oil from needle plate area before using your machine the first time.
NOTE: This machine can be used either with or without foot control.
WHEN USING POWER LINE CORD ONLY
Connect the plug of the power line cord into the cord socket (1)
and your wall outlet (2) as illustrated (A).
Set power/light switch at "OFF"
A
Mettez l'interrupteur moteur/
lumière sur "OFF"
Poner el Interruptor de corriente/
luz de velocidad en "OFF"
1
POWER/LIGHT SWITCH
Your machine will not operate until the
power/light switch is turned on. The same
switch controls both the power and the light.
When servicing the machine, or changing
needles, etc., machine must be disconnected
from the power supply.
10
2
Power line cord
Cordon
Cordón de la linea eléctrica
Power/light switch "OFF"
Interrupteur moteur/lumière "OFF"
Interruptor corriente/luz "OFF"
WHEN USING POWER LINE CORD AND FOOT
CONTROL
Connect the plug of the power line cord into the cord socket (1)
and your wall outlet (2) as illustrated (B).
Connect the foot control plug into the machine socket (3).
Set power/light switch at "OFF"
B
Mettez l'interrupteur moteur/lumière sur "OFF".
Poner el Interruptor de corriente/luz de velocidad en "OFF"
Pin plug
Butée
Pasador
Foot control
Rhéostat
Control por pedal
Always disconnect the machine from power
supply by removing the plug from the wall-outlet.
Machine socket
Connecteur de la machine
Conector de la máquina
2
1
3
Power line cord
Cordon
Cordón de la linea eléctrica
Power/light switch "ON"
Interrupteur moteur/lumière "ON"
Interruptor corriente/luz "ON"
Publicité
Table des Matières
