Moving About - Vermeiren Antares 3 Mode D'emploi

7 . I N S P E C T I O N A N D M A I N T E N A N C E

7.5 MOVING ABOUT

♦ Switch off the power with power key before moving. Always dismount from the
scooter before moving.
♦ Lift the scooter by the chassis, and not by the shroud. Lifting the scooter by the
bumper could cause damage or injury.
♦ For your safety, always ask for help if required. You will need two people when
moving or lifting the scooter whole. If you are on your own, please disassembly the
scooter before lifting. Refer to the section below.
7.6 DISASSEMBLING THE SCOOTER
Please follow the steps.
Push the Seat Rotate Lever whilst pulling up on the seat to remove.
•
Loosen the seat post knob and remove the locking pin. Then remove the upper seat
•
post
Open the battery compartment lid and lift out the battery pack.
•
Loosen the tiller adjustment knob and fold down the tiller and retighten knob.
•
Lock the front wheel and tiller by pulling the wheel lock catch down.
•
Push back on the seat post to pivot the scooter's rear section rearward until the rear
•
section is standing vertically on the rear bumper.
Unplug the electrical connector linking the front and rear sections.
•
Lift the front section up until the lower pegs are longer in contact with the curved
•
locking brackets on the rear section.
Antares
21