Wolfcraft VLC 300 Notice Originale page 12

Intended use
This appliance which does not require any further tools is suitable for cutting vinyl and laminate to size and can exclusively
be used for processing:
• self-adhesive and non-self-adhesive vinyl or PVC panels with a maximum width of 47.0 cm and a maximum thickness
of 6 mm as well as
• laminate with a maximum width of 47.0 cm and MDF/HDF boards with a thickness of 11 mm + impact sound insulation
The blade of the vinyl and laminate cutter has been made from non-wearing material and comes with a special anti-stick
coating. In order to attain the best cutting results, possible residues of glue should be removed from the blade or from
the aluminium profile. Due to its special shape, the blade needs neither be ground and sharpened nor is it admissible.
The blade holder's screwed connection should be re-tightened, if necessary.
Please note the illustrations on pages 2 - 10 how to assemble and operate the appliance.
Hint: If you want to cut vinyl and laminate of a higher thickness, the product can be screwed to a wooden plate,
so as to achieve the largest possible stability.
Operating instructions
1. Raise the cutting blade with the handle upwards
2. Push the laminate board against the guide edge, so that a precise cutting angle of 90° will be created.
Hint: Support the other end of the laminate board, so that it will be pushed horizontally against
the guide edge.
3. A clean cut is achieved by pressing the cutting blade with the handle steadily downwards.
Please make sure to push the blade straight down, in order to get an optimal result.
4. Attention: Remove the angle stop before making angular & longitudinal cuts (e.g. for the end boards).
Safety instructions:
• Operate the appliance only by using its handle; keep your fingers off the cutting area.
• Always operate the appliance alone!
• Leave the blade in its closed position, when the appliance is not in use. When opening the blade move it right to the limit stop
at rear.
• Do not make any modifications or changes to the appliance.
• Never sharpen the blade!
• Make sure that both you and the appliance have a safe position on a stable surface.
• Check before starting to work that the equipment used is properly installed (such as screwed connections).
• Make sure your clothing fits tightly (especially the sleeves) and that you wear eye protection.
• Keep children out of your workshop and store your equipment and tools in a secure place.
• Never let inexperienced personnel work with your equipment and tools without duly supervising and instructing them.
• Always work methodically, in a concentrated fashion and with sufficient lighting.
Guarantee
Dear hobbyist!
You have purchased a high-quality wolfcraft
to high technical standards, and undergo intensive development and test phases before leaving the factory. Constant controls
and regular tests during their manufacture, ensure a high quality standard. Sound technical developments, and reliable quality
controls warrant for the right choice of appliance.
We provide a warranty of 10 years from the day of purchase on the wolfcraft
used for DIY purposes. The warranty only covers damage to the item purchased, and only such damage that can be attributed
to faulty material und poor workmanship. The warranty does not cover defects and damage that must be attributed
to improper use or insufficient maintenance. Nor does the warranty cover the usual wear and tear as well as defects
and damage, of which the customer has been aware when purchasing the equipment.
Warranty claims can only be asserted by producing the invoice or the till receipt.
The warranty granted by wolfcraft
withdrawal from the contract, price reduction, claims for damages or reimbursement of expenses).
Vinyl and laminate cutter
appliance, which we know you will enjoy using. wolfcraft
®
® does not in any way restrict your statutory consumer rights (i.e. contract performance,
t
® product you acquired, provided it is exclusively
12
appliances are built
®