Remote Control; Button Description - Ferroli DIAMANT Série Manuel De L'utilisateur

1.5 REMOTE CONTROL

The remote control ("fig. 1 -") has a series of keys and a display which visualizes all the activated functions and the various parameters
the user and installer need in order to correctly use the unit itself.

Button description

1. "ON/OFF" key to turn the air conditioner on and off.
2.
"MODE" key to select the operating mode: AUTO - COOL-
DRY - FAN - HEAT:
• AUTO: The conditioner automatically sets the suitable ope-
rating mode (HEAT, DRY, FAN, COOL) depending on room
temperature.
• COOL: The unit begins to operate if the set temperature is
lower than that of the room.
• DRY for Dehumidify
• FAN: the unit get the air automatically circulating in the
room.
• HEAT: The unit begins to operate if the set temperature is
higher than that of the room.
3. "FAN" key to set the fan speed by the choosing Automatic
- low - mid - high
4.
"SLEEP" key, overnight button to set/cancel the Sleep
mode regardless of the operating mode of the conditioner.
5. "ECO" button. Activates the "energy saving" mode.
6.
"TURBO" button to enable/disable the rapid cooling mode.
7. "SELF CLEAN" button allows you to activate or deactivate
the SELF CLEAN to the drying of the internal coil in order to
prevent the formation of odors.
8. "LED" button to enable/disable the display of the unit.
9. "FOLLOW ME" button Push this button to initiate the Follow
Me feature, the remote display is actual temperature at its
location. The remote control will send this signal to the air
conditioner every 3 minutes interval until press the Follow
Me button again. The air conditioner will cancel the Follow
Me feature automatically if it does not receive the signal
during any 7 minute interval.
10. "SWING/DIRECT" buttons activate/deactivate automatic
movement of air flap.
11. "DIRECT" button adapts the direction of air flow at every
push.
12. "TIMER OFF" button to enable the TIMER mode
13. "TIMER ON" button to disable the TIMER mode
14. "TEMP" button. For setting "TEMP" (▲) it sets the increase,
(▼) sets its decline. If you activate the TIMER function ena-
bles you to set the time for switching off desired.
22
EN
1
2
3
4
6
Cod. 3QE46160 - Rev. 00 - 11/2019
DIAMANT
9
7 8
fig. 1 -
1
14
5
13
12
10
11