Other Operations Mode - Ferroli DIAMANT Série Manuel De L'utilisateur

2.5 OTHER OPERATIONS MODE

Some of the selected modes are indicated in the display while others are only implemented by the unit without any indication.
1. ECO mode (part. 1 "fig. 6 -") (the indoor unit displays shows the "E-C-O" letters one by one, followed by the temperature
setpoint). The "energy saving" mode in only available in COOL mode by pressing the "ECO" button. If the temperature setpoint
is lower than 24°C, by activating the "ECO" mode the temperature setpoint is automatically set to 24°C and fan speed to "Auto"
to save energy. If the temperature setpoint is higher than 24°C, by activating the "ECO" mode the temperature setpoint does
not change and fan speed is set to "Auto". To stop the "ECO" mode, either press the "ECO" button, or choose another operation
mode, or choose a temperature setpoint lower than 24°C
2. SLEEP function (part.2 "fig. 6 -"). Pressing the "SLEEP" button to preset the machine in night mode. The SLEEP mode is
indicated by the symbol on the display. The set point temperature will be increased (in cooling operation "COOL") or decreases
(in hot operation "HEAT") 1 ° C at predetermined intervals to a maximum of 2 ° C. SLEEP function stops automatically after 8
hours and the unit will continue operation by keeping the last setpoint. The function is not available in "FAN" and "DRY" modes.
3. FOLLOW ME function (part.3 "fig. 6 -"). Activated in HEAT - AUTO - COOL mode operation. The remote control will send this
signal to the air conditioner every 3 minutes interval until press the Follow Me button again. The air conditioner will cancel the
Follow Me feature automatically if it does not receive the signal during any 7 minute interval.
4. SELF CLEAN mode (nothing is shown on the remote, the indoor unit display shows the text "SC"). Available in COOL – DRY
modes. By pressing the "CLEAN" button, VENTILATION-HEATING-VENTILATION modes are activated in sequence to prevent
any residual condensation from forming mold and bad smells. At the end of the cycle the unit switches off automatically. If the
"CLEAN" button is pressed during the cleaning cycle, this will stop the cycle and turn off the unit.
5. TURBO mode (nothing is shown on the remote, the indoor unit display shows the text "ON" for 3 seconds when the mode is
activated, "OF" for 3 seconds when the mode is deactivated). This operation mode is only available in cool and heat mode. It
forces the unit to reach the desired setpoint as soon as possible.
6. SWING mode (nothing is shown on the remote, the indoor unit display shows the text "ON" for 3 seconds when the mode is
activated, "OF" for 3 seconds when the mode is deactivated). The automatic movement of the air flap is activated by pressing
the "SWING" button
7. DIRECT mode (nothing is shown on the remote). The air flow direction is regulated by 6° increments/decrements at each press
of the "DIRECT" button
26
EN
fig. 6 -
Cod. 3QE46160 - Rev. 00 - 11/2019
DIAMANT
1
2
3