Oase Aquarius Universal 800 Notice D'emploi page 4

- English -
Submerged installation (A)
Attention! Risk of damage! Ensure that the unit does not take in air or runs dry.
Only operate the unit with the filter housing. Cut the stepped hose adapter to suit the hose diameter and screw onto the
return (A1). Place the unit horizontally with its feet downward (A2).
Dry installation (B)
Attention! Risk of damage! Ensure that the unit does not take in air or runs dry. Do not connect the unit to a
water line.
Operate the unit without filter housing. Cut both stepped hose adapters to suit the hose diameters, then screw each
adapter on the intake and return (B1) Place the unit horizontally with its feet downward (B2). To prevent air from being
taken in, ensure that unit and supply hose are always below the water level (B2).
Start-up
Attention! The pump must never run dry.
Possible consequence: The pump will be destroyed.
Protective measure: Check the water level at regular intervals. Always place the unit below water level.
Set the flow at the controller (C).
This is how to connect the power supply:
Switching on: Connect the unit to the mains. The unit switches on as soon as the power connection is established.
Switching off: Disconnect the unit from the mains.
Attention! The installed temperature monitor automatically turns the pump off, if it is overloaded. The pump
automatically switches on again once the motor has cooled down. Risk of accident!
Install the unit so that it is not exposed to direct sun radiation (max. 104 ºF - 40 ºC).
Maintenance and cleaning
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
• Before reaching into the water, disconnect all units located in the water from the mains.
• Disconnect the unit from the mains before performing any work on the unit.
• Secure the unit to prevent unintentional switching on.
Cleaning the unit
Dismantle and clean the unit (D).
If necessary, clean the unit with clear water using a soft brush.
• In the event of stubborn furring (calcium deposits), a common household cleaner free from vinegar and chlorine can
be used. Subsequently, clean the pump thoroughly using clear water.
• Never use aggressive cleaning agents or chemical solutions. These could attack the housing surface or impair the
function.
4