Alerts At Activation; Locking For Repeated Incorrect Codes - MetaSystem VESTHA THS501 Manuel D'utilisation

HomeAlarm MetaSystem
EN
Fig.4a
2.3. Indications when enabling
When the system is enabled the ACTIVE indicator light is on and flashing. In the presence of T519 the REMOTE
indicator light (red) is also on. The T519 remote LED is useful in understanding from outside if the system has
been enabled.
If the unit signals anomalies or alarm memories when enabling with the remote control, the system will turn
on, signalling the anomaly with 4 short BEEPs.
ACTIVE green
indicator light
Fig.5

2.4. Locking for repeated incorrect codes

Inputting 3 wrong unlock codes generates an alarm cycle of the control unit and the activation of the phone
dialler, which will send a message of "ERROR!!!" "WRONG PASSWORD" to the numbers entered in the Alarm
list. The system will stay locked for 10 minutes, during which it will not be possible to use the correct unlock
code. The alarm cycle that has been triggered may be interrupted with the radio controls stored in the control
unit.
16
Fig.4b
BEEP - BEEP
BEEP - BEEP -
PARTIAL yellow
indicator light
Fig.4c
REMOTE red
indicator light
BEEP