PYRAMID controls
GB
Models with mechanical keypad
IHP 6.5 C M IX - IHP 6.5F C M IX
IHP 6.5F C M K - IHP 9.5F C M IX
IHP 9.5 C M IX - IHP 7.5 C M IX
T1
T2
T1 Motor reset
Pressing the button while the hood is in operation turns it
OFF.
T2 Speed 1
Pressing the button sets the hood to speed 1.
T3 Speed 2
Pressing the button sets the hood to speed 2.
T4 Speed 3
Pressing the button sets the hood to speed 3.
T5 Lights ON/OFF
Maintenance and care
Caution! Before cleaning or servicing the unit,
disconnect it from the mains by pulling the power plug
or disconnecting the main circuit breaker.
First cleaning
• Remove the protective film
• Clean with a damp sponge and a little neutral soap
• Rinse off with a damp cloth
• Dry with a soft cloth; if the hood is stainless steel, dry
along the metal's grain
Periodic cleaning
The hood must be cleaned frequently (at least as often as
you service the grease filter), inside and out. Use a damp
cloth and a neutral liquid detergent with lukewarm water.
Do not use abrasive or corrosive products.
Warning: Failure to observe the hood cleaning and filter
cleaning/replacement instructions can result in fires. Follow
the instructions carefully. The manufacturer is not liable for
any damage to the motor or fires caused by incorrect care
or failure to follow the above instructions.
38
T3
T4
T5
Servicing the grease filter (A)
A
If washed in a dishwasher, the metal filter may change
colour, but this does not affect its performance.
Servicing the charcoal filter (B)
B
or regenerated
Disassembly: Rotate the filter 90° to remove it from the
suction assembly.
Assembly: Fit the active-carbon filter into the suction
assembly and rotate it 90° to secure it in place.
Replacing the bulbs
Disconnect the unit from the mains and remove the grease
filter.
Caution! Make sure the bulbs are cool before touching
them.
1. Extract the guard
by prising it out with a small
flat head screwdriver or
something similar.
2. Replace the faulty bulb.
Use only bulbs of the
same type (for details,
see the technical data in
the following manual).
3. Refit the guard (push it in).
Replacing the lights LED
The hood is fitted with a lighting system based on LED
technology. The LEDs ensure optimal lighting, longer life
and lower consumption compared with traditional lights. To
replace them please contact the assistance service.
Electrical cable
If the power cable is damaged, it can be replaced by the
manufacturer or his technical service, to prevent any
attendant risks.
*
Only available in certain models
The grease filter retains the
particles of grease produced
during cooking; it must be
cleaned at least once a month
w i t h a n o n - a g g r e s s i v e
detergent, either by hand or
with a low temperature, short
dishwasher cycle.
To extract the grease filter,
pull the spring loaded handle.
The charcoal filter retains
unpleasant cooking odours.
The filter saturates after a
variable time, depending on
the type of cooking and how
often the grease filter is
cleaned. The cartridge must
be replaced at least once
every twenty months.
This filter can NOT be washed
*