Gloria MULTIBRUSH li-on Mode D'emploi page 26

OVERLOAD PROTECTION!
Your MultiBrush li-on has protection
against overloading. The unit switches
off automatically if you stress it excessi-
vely (too much pressure on the brush). In
this case you should release the On / Off
safety switch (D) to reset the overload
protection. Switching on again with the
On / Off safety switch (D) allows you to
continue working immediately with the
MultiBrush li-on. Reduce the force
applied to the brush by not pressing so
hard.
TEMPERATURE PROTECTION
Your MultiBrush li-on has protection
against excessively high temperatures of
the rechargeable battery. The battery
cells can overheat if you use the unit
constantly over a longer period of time
or if it is exposed to high ambient tem-
peratures. In such a case the unit swit-
ches off automatically. Allow the rechar-
geable battery (C) to cool down again
before switching on again.
LOW VOLTAGE CUTOFF DEVICE!
Your MultiBrush li-on has a low voltage
cutoff device for the rechargeable batte-
ry. This functions switches the unit off
immediately if the voltage falls below a
specified value. In such a case you
should recharge the battery (C) or else
put a fully charged battery into the unit.
CAUTION! RISK OF BURNS
CAUSED BY HOT PARTS!
Parts of the device can become hot
during use and may cause burns.
It is therefore important to observe
the following safety instructions:
Wear protective gloves during
assembly and cleaning work!
Observe the following safety
precautions to prevent injuries
and material damage due to misuse
and unsafe handling of the product.
Misuse can result in INJURIES.
CAUTION! RISK OF INJURY
DURING OPERATION!
Use the device as intended!
Work only within the specified
perform ance range.
Before each use, make sure that the
device is in perfect condition;
operation is prohibited if:
- the safety devices (start switch,
protective covers) and/or brushes
are damaged or worn.
- the device shows visible signs of
damage.
- the device may have been
dropped before.
- foreign objects have wrapped
around the drive shaft.
Never disable any safety devices.
Check area to be cleaned
beforehand to avoid damage to
device / objects or injuries to living
beings. Stones, pieces of wood,
wires or the like, as well as other
foreign objects must be removed.
Objects that are caught by the
brushing equipment can be flung
out uncontrollably. Keep bystanders
away from the danger zone. In order
to prevent injuries, pay attention to
safety in the work area.
Never use the device on house walls
or similar, always work vertic ally so
that the brushes are pointed at the
ground.
Ensure that the ventilation slots are
free of dirt.
CAUTION! RISK OF INJURY FROM
ROTATING BRUSHING TOOL!
Never start the device in a
tilted position!
Never put your hands or
feet near to the rotat ing
brushing equipment!
Ensure that sufficient
distance is kept between
hands, feet and brushing
equipment. Brushing tools
continue to turn.
Never lift or carry the device with
running motor! Switch motor off
and remove battery when moving
device to and from work area,
or tilting device.
Never remove the supplied safety
guards.
26