9
Maintenance & Cleaning
CAUTION! RISK OF BURNS
CAUSED BY HOT PARTS!
During assembly or conversion work
the drive parts of the device or compo-
nents can still be very hot and may
cause burns.
It is therefore important to observe the
following safety instruction:
Wear protective gloves during
maintenance and cleaning!
9.1 Cleaning
ATTENTION! Improper use of the
device poses a risk of damage to
property!
You should therefore observe the
following safety instruction:
Do not immerse the device in water or
spray or clean it with water.
The device must be protected against
moisture.
Clean the outside of the device with a
damp cloth or soft brush. Do not use
abrasives or harsh cleaning agents.
Ensure that the ventilation slots are free
of dirt.
In cases of heavier soiling of the roller
brush and/or joint brush units,
dismantle for thorough cleaning (see
Assembly/Disassembly as described in
Chapter 7.1.3).
Clean the brushes in water or with a
strong water jet and a hard brush.
Only use original GLORIA spare parts.
Repairs must be carried out by a
GLORIA service point.
9.2 Wear of the brushes
NOTE!
If the surface brush wears down to a
diameter of ø approx. 90 mm, it must
be replaced.
If the joint brush wears down to a
diameter of ø approx. 90 mm, it must
be replaced.
10 Disposal & Legislation
10.1 Environmental protection &
disposal of the device
This symbol on the product, user manu-
al or packaging indicates that this prod-
uct must not be disposed of in regular
household waste at the end of its service
life.
According to European Directive
2012/19/EU, electrical and electronic
devices that can no longer be used –
including accessories such as surface
brushes and joint brushes – must be col-
lected separately and reused or recycled
in an environmentally friendly manner.
The installed Lithium-Ion battery must
be disposed of separately from the rest
of the device.
NOTE!
Please check with your local govern-
ment to find the appropriate disposal
point.
35