Isotronic Diamant Mode D'emploi page 10

2. Installation and maintenance
Insert the device into the ground, so that up to ¾ of the aluminium stake is
beneath the surface. Remove the plastic foil in the transparent part of head of
the product before using (battery is on power now, see also 3. Replacement
of the rechargeable battery). To start up, select the operating mode on the
underside of the housing. The animal repellent device is now ready for operation.
Check the function of the device regularly. In case it does not work normally any
more, a replacement of the rechargeable battery might be necessary (
Operating modes
1: [On] Tone frequency
2: [On] Vibration motor
3: [On] Tone frequency + vibration motor (Parallel operating mode)
4: [On] Tone frequency + vibration motor (Alternate operating mode)
5: Switch off the device
Installation suggestion (see drawing):
Place the repeller in such a position that animals will have the possibility to flee
from your land. After about 5-6 weeks the device/s should be moved
approximately 4-5 metres in the direction of the escape route.
3. Replacement of the rechargeable battery
1. Remove the transparent housing cover.
2. Carefully take off the solar panel from the rechargeable battery which is
underneath. When doing so, make sure that the cable connection between the
solar panel and the circuit board which is underneath the rechargeable battery,
is left intact and is not damaged.
3. Remove the old rechargeable battery from its fitting.
see point 3).