Dolmar TM-98.14 H2D Manuel D'utilisation page 111

HOW TO USE THE MACHINE
WARNING!
!
Clean the plastic parts of the body with a damp sponge using water and detergent,
taking care not to wet the engine, the electrical parts or the electronic circuit board
located under the dashboard.
IMPORTANT
work or the engine!
When washing the inside of the cutting deck
the machine must be on firm ground with:
– the stone-guard fitted;
– the operator seated;
– the engine running;
– the transmission in neutral;
– the blades engaged.
Connect a water hose to each of the pipe fit-
tings (1) one at a time and run water through
each one for a few minutes, with the blades
moving.
When washing, the cutting deck should be lowered right down.
5.4.9 Storage and inactivity for long periods
If you intend not to use the machine for a long period (more than 1 month), disconnect
the battery cables and follow the instructions in the engine instruction manual.
Empty the fuel tank by disconnecting the tube situated
at the inlet of the fuel filter (1) and follow the instruc-
tions in the engine manual.
WARNING!
!
cuttings which may have collected around the
Do not leave containers full of cut grass inside a room.
Never use hose nozzles or harsh detergents to clean the body-
Carefully remove any dry grass
1
25
EN
1