Dolmar TM-92.14 Manuel D'utilisation page 108

22
EN
Mechanical transmission:
«FAST», and the gear lever in 1st gear (
Keep the pedal pressed down and release the parking brake. Slowly release the
pedal to shift from "brake" to "clutch", thus operating the rear wheels (
WARNING!
!
engagement may cause the vehicle to tip over and the driver to lose control.
Gradually reach the desired speed using the throttle and gear lever. To change gear,
press the clutch halfway down (
Hydrostatic transmission:
another, position the throttle between «SLOW» and «FAST».
Disengage the parking brake and release the brake pedal (
Press the drive pedal (
gradually increasing pressure on the pedal and working the throttle.
WARNING!
!
sudden engagement from causing tipping up and loss of control of the vehicle,
particularly on slopes.
5.4.3 Braking
First reduce the machine's speed by reducing the engine's r.p.m., and then press the
brake pedal ( 4.21 or 4.31) to slow down the machine until it stops.
Hydrostatic transmission:
by just releasing the drive pedal.
Position the throttle between «SLOW» and
The pedal has to be released gradually, as a sudden
4.21).
When moving the machine from one area to
4.32) in direction «F» and reach the required speed by
Drive must be engaged as described (
The machine already slows down considerably
HOW TO USE THE MACHINE
4.22).
4.21).
4.31).
4.32) ) to prevent