Christopeit Sport CT 2 Notice De Montage Et D'utilisation page 21

Step 6:
Attach the pulse grip (8) and handgrips (7).
1. Put the handgrip bars (7L+7R) onto the connecting tubes (6L+6R)
and adjust the holes in the tubes so that they are aligned. (Note:
the handgrip bars must be aligned after assembly so that the
upper ends are inclined outwards (away from the support (2)).
2. Push the bolt M8x16 (16) through the holes and tighten the
handgrip bars (7) at connection tubes (6) with washers 8/19 (44),
and spring washers M8 (52) firmly.
3. Guide the pulse grip (8) through the appropriate holder of support
(2) and adjust the holder so that the holes and threats align. Put
on each screw M8x30 (51) one spring washer M8 (82) and one
washer 8/16 (31) and tighten the pulse grip (8) at the support (2)
firmly.
4. Put the pulse cable (50) through the holes at support (9) into top
position and attach the grip cover (53) onto pulse grip connection
point.
Step 7:
Attach the computer (9) at support (2).
1. Take the computer (9) that has been supplied out of the
packaging and insert the batteries (Type "AA"-1.5 V pencells) by
watching for the right polarity on the back of the computer (9).
(Batteries for the computer are not included in this item. Please
buy them at your located market.)
2. Place the computer (9) to support (2) and put the plug of
connection cable (18) into the socket from monitor (9) backside
and insert the plugs of pulse (50) too. Push the computer (9) to
top monitor bracket of front post (2) and secure with screws
M4x12 (55) and washer 4//10 (66).
(Attention: Ensure that the cable looms are not crunched or
pinched during installation. The screws for computer you find
on backside of computer)
21