Disposal - Junker JP4119260 Manuel D'utilisation Et Notice D'installation

11.1 Malfunctions
Fault
The appliance is not
working.
Food takes longer
than usual to heat up.
Turntable grates or
grinds.
Microwave mode is
cancelled.
The appliance is not
in operation. A cook-
ing time is shown in
the display.
Three zeros flash on
the display.
An is shown on the
display.
The message ap-
pears on the display.
12 Disposal
Find out here how to dispose of old appliances cor-
rectly.
12.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
Dispose of the appliance in an environmentally
▶
friendly manner.
Cause and troubleshooting
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
▶
The circuit breaker in the fuse box has tripped.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other appliances are working.
▶
Malfunction
Switch off the fuse in the fuse box.
1.
Switch the fuse back on after approx. 10 seconds.
2.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales service. Please specify the exact error
3.
message when calling.
→ "Customer Service", Page 34
Door is not fully closed.
Check whether food remains or foreign material are trapped in the door.
▶
The microwave power setting is set too low.
Set a higher microwave power setting. → Page 28
▶
You have placed a larger amount of food than normal in the appliance.
Set a longer cooking time.
▶
You need double the time when you have double the amount.
The food is colder than usual.
Turn or stir the food from time to time during cooking.
▶
There is dirt or foreign objects in the area of the turntable drive.
Clean the roller ring and recess in the cooking compartment.
▶
Appliance has a fault.
If this fault recurs, call the after-sales service.
▶
The settings area has been activated accidentally.
Press ⁠ .
▶
was not pressed after the setting was implemented.
Press or delete the setting by pressing
▶
There has been a power cut.
Reset the time.
▶
→ "Initial configuration", Page 27
Demo mode is activated.
Fault in the automatic door opening system.
Switch off the appliance.
1.
Wait for 10 minutes.
2.
Switch the appliance on again.
3.
If this fault recurs, call the after-sales service.
▶
⁠ .
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
Disposal en
33