Cleaning; Troubleshooting - Panasonic KY-T936SL Mode D'emploi

Cleaning

CAUTION
■ Before cleaning, turn off the main power switch. Allow to cool
before cleaning the top plate.
■ Do not use a steam cleaner. Water may get into the electrical
components and cause damage.
Always keep the appliance in a clean condition.
Spilled food or oil scorched on the appliance may
become difficult to clean.
Top Plate and Control Panel
Light stains
Wipe off with a damp cloth.
Oil stains
■ Wipe off with a cloth dampened in mild detergent.
■ Do not use strong acidic or alkaline detergents, such
as bleach or synthetic detergents. They may cause
discolouration.
Heavy stains
Apply non-abrasive cream cleaner to the top plate or
control panel and wipe with a cloth.
NOTE
Ensure there are no stains on the base of the cookware.
30
EN-

Troubleshooting

Check the following for some advice on rectifying some common problems before
calling the service centre.
Power Source
Symptom Possible cause
The appliance cannot ■ The main power switch has not been turned ON.
be turned ON. Touch the main power switch a little longer.
■ Child Lock has been activated. (See page 11)
Auto switch off
If 1 minute has elapsed without any operation after
switching on, the main power automatically turns off.
Turn on the main power switch again.
The cooking zone Long cooking time
turned itself off while in If no key is touched for a set time (see table below)
operation. when a cooking zone is in operation, a beep will sound
and the cooking zone is turned off automatically.
Set the appliance again as required.
It is recommended to use the Cooking Timer when
simmering for a long period of time. (See page 25)
Low
1 1. 2 2. 3 3. 4 4. 5 5. 6 6. 7 7. 8 8. 9
Auto switch off time
9 8
(hours)
Control Panel
Symptom Possible cause
Key operation is ■ Your fingertips are covered. Touch with bare finger.
disabled.
■ Control Panel Lock is activated. (See page 12)
■ You performed the operation while holding the
cookware handle.
■ The control panel is dirty.
Turn off the main power switch and ensure the area
is clean and dry. Turn on the main power switch
again.
Keys react when the Water or other liquids may be on or around the control
surrounding area is panel.
touched. Ensure the area is clean and dry.
Power Level
Medium High
7 6 5 4 3 2 1
31
EN-