Danby DPA060BACBDB Guide D'utilisation Et D'entretien page 11

Operating Instructions
REPLACING THE REMOTE BATTERIES
Your air conditioning unit comes with two AAA batteries. Place the bat-
teries in the remote control before use.
1. Slide the back cover from the remote downward to expose the battery
compartment.
2. Insert the batteries, ensure to match the (+) and (-) symbols on the
ends of the batteries with the symbols inside the battery compartment.
3. Slide the battery cover back into place.
• The air conditioner will not respond if curtains, doors or other materials
block the signal from the remote control to the unit.
• Prevent any liquid from contact with the remote control. Do not expose
the remote control to direct sunlight or heat.
• If the infrared signal receiver on the indoor unit is exposed to direct
sunlight, the air conditioner may not function properly. Use curtains to
prevent the sunlight from falling on the receiver.
• Do not mix old and new batteries or batteries of different types.
• Do not leave the batteries in the remote control if it is not going to be
used for more than 2 months.
IMPORTANT
Do not dispose of batteries as unsorted municipal waste.
Refer to local laws for proper disposal of batteries.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residen-
tial installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna
2. Increase the separation between the equipment and receiver
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
4. Consult the dealer or an experienced radio/TV technician for help
Changes or modifi cations not approved by the party responsible for FCC compliance could void the user's authority to
operate the equipment. This appliance complies with Part 15 of the FCC Rules.
Operation is subject to the following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
This device complies with Canadian CAN ICES-3 (B) / NMB-3 (B)
8