Danby DPA060BACBDB Guide D'utilisation Et D'entretien page 9

Operating Instructions
OPERATING MODES
Timer Operation
Note: Timer function can only be activated by the remote control.
This unit has two timer related functions:
• Timer on: sets the amount of time after which the unit will turn on
• Timer off: sets the amount of time after which the unit will turn off
Timer On Function:
• Press the Timer On button on the remote control
• The last time period that was set will show on the display
• Press the Timer On button repeatedly to set the amount of hours that should pass before the unit
turns on
• Wait two seconds for the programming to be accepted by the unit
Timer Off Function:
• Press the Timer Off button on the remote control
• The last time period that was set will show on the display
• Press the Timer Off button repeatedly to set the amount of hours that should pass before the unit
turns off
• Wait two seconds for the programming to be accepted by the unit
Notes:
• Pressing the Timer On or Timer Off buttons will increase the set time in 0.5 hour increments up to
10 hours and then in 1 hour increments up to 24 hours
• The display will revert back to showing the previous temperature setting if the unit does not re-
ceive a signal within a 5 second period during programming
• Adjusting the timer setting to 0.0 hours will cancel the Auto-timer settings
Using the Auto-on and Auto-off feature at the same time
You can set the air conditioner to run the Auto-on and Auto-off features at the same time. Keep in
mind that the hours displayed on the unit refer to the number of hours that will pass from the current
time before the action is taken.
For example:
• First, set the Timer On or Timer Off function as per above
• Wait three seconds for programming to be accepted by the unit
• Set the Timer Off or Timer On function
• Wait three seconds for programming to be accepted by the unit
Auto-Restart: If the unit looses power unexpectedly, it will restart with the previous function settings
when power is restored.
Note: Once the unit has stopped, it cannot be restarted for 3 minutes. Operation will resume after 3
minutes.
6