Danby DPA080UB1GDB Guide D'utilisation Et D'entretien page 10

Features
ELECTRONIC CONTROL
INSTRUCTIONS
POWER button
1
Turns power on/off.
2
FAN Indicator
3
COOL Indicator
4
DRY Indicator
5
UP and DOWN buttons
Used to adjust (increase / decrease) temperature settings
(1°C/1°F increments) in a range of 17°C (62°F) to 30°C (86°F).The control is
capable of displaying temperature in degrees Fahrenheit or
degrees Celsius. To convert from one to the other, press and
hold the Up and Down buttons at the same time for 3 seconds.
5
MODE select button
6
Selects the appropriate operating mode. Each time you press
the button, a mode is selected in a sequence that goes from
COOL, FAN and DRY. The mode indicator light illuminates depending
on the mode settings.
LED DISPLAY
7 Shows the set temperature in °C or °F and the Auto-timer settings.
While on DRY and FAN modes, it shows the room temperature.
Error codes:
E1 - Room temperature sensor error -Unplug the unit and plug
it back in. If error repeats, call for service.
E2 - Evaporator temperature sensor error- Unplug the unit and
plug it back in. If error repeats, call for service.
E4 - Display panel communication error - Unplug the unit and
plug it back in. If error repeats call for service.
P1 - Bottom tray is full - Connect the drain hose and drain the
collected water away. If error repeats, call for service.
Power indicator
light
6
Timer indicator
light