Simpson MS60753 Manuel D'utilisation page 18

5. Squeeze bottle to inject contents into pump.
6. With ignition switch off, simultaneously pull starter rope and squeeze bottle.
Repeat until protector fluid exits pump outlet. NOTE: This step may require
two people.
pRESSURE WASHER
1. Drain all water from high pressure hose and wrap it onto hose wrap.
2. Drain all water from the spray gun and wand by holding spray gun in a vertical
position with nozzle end pointing down and squeezing trigger. Store in gun
holder.
3. Wrap up and secure detergent siphon hose so it is protected from damage.
DANGER: Risk of fluid injection. When using replacement spray wands or
guns with this pressure washer, DO NOT use a spray wand and/or spray gun/
wand combination that is shorter in length than what was provided with this
pressure washer as measured from the nozzle end of the wand to the gun
trigger.
NOTICE: The use of any other accessory not recommended for use with this tool
could be hazardous. Use only accessories rated equal to or greater than the rating
of the pressure washer.
Model
PSI Max*
GPM Max*
High Pressure Hose
Presure of Inlet Water
Inlet Water
Soap Consumption Rate
* R ated Pressure and Rated Water Flow is within manufacturing tolerance of
(+/- 10%).
In a continued commitment to improve quality, the manufacturer reserves the right
to make component changes, design changes, or specification changes when
necessary and without notice.
Do not return this product to your retailer. Please contact our customer service
department at www.simpsoncleaning.com
90 DAY LIMITED WARRANTY ON pRODUCT COMpONENTS EXCLUDING pUMp
SIMPSON
® warrants to the original purchaser that the wheels, gun, hose, wand, spray
nozzle(s) and other components of the
warranty are free from defects in material and workmanship for 90 days from the date
of purchase.
ACCESSORIES
SpECIFICATIONS
MS60753
2800 PSI
2.3 gpm
25 ft. (7.6 m)
20–100 PSI
cold tap (100 °F max)
10% max
SERvICE INFORMATION
LIMITED WARRANTY
SIMPSON
18- ENG
pressure washer covered under this
®