Publicité
Les langues disponibles
Les langues disponibles
f.
Detergent Siphon hose (not shown): Feeds cleaning agents into the pump
to mix with the water. See how To Apply Chemicals/Cleaning Solvents
instructions in Operation section.
G. handle
h. frame
I.
Pump Outlet
J.
Pump Inlet
k. Quick Connect Nozzles
BASIC ELEMENTS OF AN ENGINE
Refer to the Engine Owner's Manual for location and operation of engine controls.
Choke Control: Opens and closes carburetor choke valve.
Starter Grip: Pulling starter grip operates recoil starter to crank engine.
Engine Switch: Enables and disables ignition system.
1.
Locate and remove all loose parts from the carton.
2.
Cut four corners of the carton from top to bottom and lay the panels flat.
3.
Place handle (G) onto frame (H),
depress the snap buttons, and slide
the handle assembly onto the frame
until snap buttons snap into place.
NOTICE: Risk of personal injury. Avoid
placing hands between handle and
frame when assembling to prevent
pinching.
4.
Remove the colored quick-connect nozzles (K) from the plastic bag and insert
them into correct grommet on the nozzle holder. Nozzles are color coded to
match colored nozzles on label (L).
5.
Connect wand (E) to gun (D). Tighten securely.
6.
Attach high pressure hose (C) to gun (D). Tighten se cure ly.
D
NOTICE: The engine is shipped without oil. Before starting engine, add the oil
provided. Damage to the engine will occur if the engine is run without oil, this
damage will not be covered under warranty.
NOTE: The pump on this unit is maintenance free and requires no oil. If
there is a problem with the pump, contact our Customer Service Group on
www.simpsoncleaning.com as soon as possible.
ASSEMBLY INSTRUCTIONS (FIG. 2–4)
3
2
G
h
4
E
11 - ENG
2A
k
L
D
C
Publicité
