Télécharger Imprimer la page

Simpson 7111290 Manuel D'utilisation page 14

Publicité

Les langues disponibles

Les langues disponibles

NOZZLE COLOR SPRAY PATTERN USES
Yellow
Green
White
Black
*NOTICE: The high pressure spray from your pressure washer is capable of
causing damage to surfaces such as wood, glass, automobile paint, auto striping
and trim, and delicate objects such as flowers and shrubs. Before spraying,
check the item to be cleaned to assure yourself that it is strong enough to resist
damage from the force of the spray.
HOW TO APPLY CHEMICALS/CLEANING SOLVENTS (FIG. 9)
Applying chemicals or cleaning solvents is a low pressure operation. NOTE: Use
only soaps and chemicals designed for pressure washer use. Do not use bleach.
To Apply Chemicals:
1.
Ensure detergent siphon hose (F, Figure 9) is
attached to barbed fitting location near high
pressure hose connection of pump as shown.
2.
Place other end of detergent siphon hose with
filter on it into container holding chemical/cleaning
solution. NOTE: For every 7 gallons of water
pumped 1 gallon of chemical/cleaning solution will
be used.
3.
Install the black low pressure nozzle into the quick connect fitting of the spray
wand. (if equipped) Rotate the Dial-N-Wash (L) to the MAX pressure setting as
shown in Figure 6. See How To Use Spray Wand paragraph in this section.
NOTE: To apply chemicals the black low pressure nozzle must be installed and
the Dial-N-Wash must be in the MAX pressure setting as shown in Figure 6.
4.
After use of chemicals, place detergent siphon hose into container of clean
water and draw clean water through chemical injection system to rinse sys-
tem thoroughly. If chemicals remain in the pump it could be damaged. Pumps
damaged due to chemical residue will not be covered under warranty.
NOTE: Chemicals and soaps will not siphon if the black soap nozzle is not installed
on the spray wand.
15˚
25˚
40˚
low pressure
intense cleaning
of unpainted
hard surfaces
intense cleaning of
larger areas
cleaning of
painted or delicate
surfaces
applies cleaning
solutions
14- ENG
SURFACES*
grills, driveways,
concrete or brick
walkways, unpainted
brick or stucco
metal, concrete or wood
auto/RV, marine,
wood, painted brick
and stucco, vinyl,
painted siding
Low pressure
spray is safe on all
surfaces. Always verify
compatibility of cleaning
solution prior to use.
9
F

Publicité

loading