Publicité
Les langues disponibles
Les langues disponibles
G. Handle
H. Frame
I.
Pump Outlet
J.
Pump Inlet
K. Quick Connect Nozzles
L.
Dial-N-Wash
Use the Dial-N-Wash to increase and decrease the pressure. Refer to the Dial-
N-Wash Adjustment paragraph.
BASIC ELEMENTS OF AN ENGINE
Refer to the Engine Owner's Manual for location and operation of engine controls.
Choke Control: Opens and closes carburetor choke valve.
Starter Grip: Pulling starter grip operates recoil starter to crank engine.
Engine Switch: Enables and disables ignition system.
1.
Locate and remove all loose parts from the carton.
2.
Cut four corners of the carton from top to bottom and lay the panels flat.
3.
Place handle (G) onto frame (H),
depress the snap buttons, and
slide the handle assembly onto the
frame until snap buttons snap
into place.
NOTICE: Risk of personal injury.
Avoid placing hands between handle
and
frame
when
prevent pinching.
4.
Remove the colored quick-connect nozzles (K) from the plastic bag and insert
them into correct grommet on the nozzle holder. Nozzles are color coded to
match colored nozzles on label (Q).
5.
Connect wand (E) to gun (D). Tighten securely.
6.
Attach high pressure hose (C) to gun (D). Tighten se cure ly.
3
D
NOTE: The pump on this unit is maintenance free and requires no oil. If
there is a problem with the pump, contact our Customer Service Group on
www.simpsoncleaning.com as soon as possible.
NOTICE: The engine is shipped without oil. Before starting engine, add the oil
provided. Damage to the engine will occur if the engine is run without oil, this
damage will not be covered under warranty.
Adjustable Pressure Regulator (if equipped, not shown):
®
ASSEMBLY INSTRUCTIONS (FIG. 2 – 4)
assembling
2
G
H
to
4
E
11 - ENG
2A
K
Q
D
C
Publicité
