Publicité
Les langues disponibles
Les langues disponibles
Connection/Installation
Cautions
• Run all ground (earth) leads to a
common ground (earth) point.
• Do not get the leads trapped under a
screw, or caught in moving parts (e.g., seat
railing).
• Before making connections, turn the car
ignition off to avoid short circuits.
• Connect the power supply leads to the
unit and speakers before connecting it to
the auxiliary power connector.
• Be sure to insulate any loose unconnected
leads with electrical tape for safety.
• Choose the installation location carefully so
that the unit will not interfere with normal
driving operations.
• Avoid installing the unit in areas subject to
dust, dirt, excessive vibration, or high
temperature, such as in direct sunlight or
near heater ducts.
• Use only the supplied mounting hardware
for a safe and secure installation.
Note on the power supply lead (yellow)
When connecting this unit in combination with
other stereo components, the amperage rating of
the car circuit to which the unit is connected must
be higher than the sum of each component's fuse
amperage rating.
Note on installing in cars with a start-stop
system
The unit may restart when starting the engine from
start-stop. In this case, turn off the start-stop
system of your car.
Mounting angle adjustment
Adjust the mounting angle to less than 30°.
10
GB
Parts List for Installation
Mounting sleeve (1)
Trim ring (1)
Bushing (1)
Microphone (1)
Double-sided tape (1)
• This parts list does not include all the
package contents.
• The mounting sleeve and the trim ring
are attached to the unit before shipping.
Before mounting the unit, use the release
keys to remove the mounting sleeve
from the unit. For details, see "Removing
the trim ring and the mounting sleeve"
(page 14).
• Keep the release keys for future use as
they are also necessary if you remove the
unit from your car.
Release keys (2)
Securing screw (1)
Power supply leads (1)
Flat-mount base (1)
Publicité
