Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operations
Using digital audio output device
You can connect the CD player, etc. with coaxial digital
cable (not supplied)/optical digital audio cable (not
supplied) to this unit and play back music.
CD player, etc.
Using coaxial digital cable
1 Disconnect the AC power supply cord.
2 Connect this unit and a CD player, etc.
3 Connect the AC power supply cord to
this unit. ( 15)
4 Press [AMP
] to turn this unit on.
5 Press [>INPUT<] repeatedly to select
"COAX1" or "COAX2".
• You can also select the input source by
turning the input selector knob on the unit.
6 Start playback on the connected
device.
Note
• The digital audio input terminals of this unit can
only detect the following linear PCM signals.
For details, refer to the operating instructions of
the connected device.
- Sampling frequency:
Coaxial digital input
32/44.1/48/88.2/96/176.4/192 kHz
Optical digital input
32/44.1/48/88.2/96 kHz
- Number of quantization bits:
16/24 bit
16
(16)
Optical digital audio cable
(not supplied)
Coaxial digital cable
(not supplied)
Using optical digital audio cable
1 Disconnect the AC power supply cord.
2 Connect this unit and a CD player, etc.
3 Connect the AC power supply cord to
this unit. ( 15)
4 Press [AMP
] to turn this unit on.
5 Press [>INPUT<] repeatedly to select
"OPT1" or "OPT2".
• You can also select the input source by
turning the input selector knob on the unit.
6 Start playback on the connected
device.
Publicité
Table des Matières
