English - Indesit ISLK 66 LS K Mode D'emploi

English

EN GENERAL SAFETY
• Before any cleaning or maintenance operation,
disconnect hood from the mains by removing the plug
or disconnecting the mains electrical supply.
• Always wear work gloves for all installation and
maintenance operations.
• This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe
way and understand the hazards involved.
• Children shall not be allowed to tamper with the
controls or play with the appliance.
• Cleaning and user maintenance shall not be made
by children without supervision.
• The premises where the appliance is installed must
be sufficiently ventilated, when the kitchen hood is
used together with other gas combustion devices or
other fuels.
• The hood must be regularly cleaned on both the
inside and outside (AT LEAST ONCE A MONTH).
• This must be completed in accordance with the
maintenance instructions provided. Failure to follow
the instructions provided regarding the cleaning of the
hood and filters will lead to the risk of fires.
• Do not flambé under the range hood.
• For lamp replacement use only lamp type indicated
in the Maintenance/Replacing lamps section of this
manual.
The use of exposed flames is detrimental to the filters
and may cause a fire risk, and must therefore be
avoided in all circumstances.
Any frying must be done with care in order to make
sure that the oil does not overheat and ignite.
CAUTION: Accessible parts of the hood may become
hot when used with cooking appliances.
• Do not connect the appliance to the mains until the
installation is fully complete.
• With regards to the technical and safety measures to be adopted for fume
discharging it is important to closely follow the regulations provided by the local
authorities.
• The air must not be discharged into a flue that is used for exhausting fumes
from appliance burning gas or other fuels.
• Do not use or leave the hood without the lamp correctly mounted due to the
possible risk of electric shocks.
• Never use the hood without effectively mounted grids.
• The hood must NEVER be used as a support surface unless specifically
indicated.
• Use only the fixing screws supplied with the product for installation or, if not
supplied, purchase the correct screws type.
• Use the correct length for the screws which are identified in the Installation
Guide.
• In case of doubt, consult an authorized service assistance center or similar
qualified person.
WARNING!
• Failure to install the screws or fixing device in accordance with these
9
instructions may result in electrical hazards.
• Do not use with a programmer, timer, separate remote control system or
any other device that switches on automatically.
The hood can look different to that illustrated in the drawings in this
booklet. The instructions for use, maintenance and installation, however,
remain the same.
Closely follow the instructions set out in this manual. All responsibility, for
any eventual inconveniences, damages or fires caused by not complying with the
instructions in this manual, is declined. This appliance is intended to be used in
household and similar application such as: - staff kitchen areas in shop, offices
and other working environments; - farm houses; - by clients in hotels, motels and
other residential type environments; - bed and breakfast type environments.
• It is important to conserve this booklet for consultation at any moment. In
the case of sale, cession or move, make sure it is together with the product.
• Read the instructions carefully: there is important information about
installation, use and safety.
• Do not carry out electrical or mechanical variations on the product or on the
discharge conduits.
• Before proceeding with the installation of the appliance verify that there are
no damaged all components. Otherwise contact your dealer and do not
proceed with the installation.
The minimum distance between the supporting surface for the cooking
equipment on the hob and the lowest part of the range hood must be not less
than 60cm from electric cookers and 75cm from gas or mixed cookers.
If the instructions for installation for the gas hob specify a greater distance, this
must be adhered to.
Expansion wall plugs are provided to secure the hood to most types of
walls/ceilings. However, a qualified technician must verify suitability of the
materials in accordance with the type of wall/ceiling. The wall/ceiling must be
strong enough to take the weight of the hood.
Do not tile, grout or silicone this appliance to the wall. Surface mounting
only.
ELECTRICAL CONNECTION
The mains power supply must correspond to the rating indicated on the plate
situated inside the hood. If provided with a plug connect the hood to a socket in
compliance with current regulations and positioned in an accessible area, after
installation. If it not fitted with a plug (direct mains connection) or if the plug is not
located in an accessible area, after installation, apply a double pole switch in
accordance with standards which assures the complete disconnection of the
mains under conditions relating to over-current category III, in accordance with
installation instructions.
WARNING!
Before re-connecting the hood circuit to the mains supply and checking the
efficient function, always check that the mains cable is correctly assembled.
Replacing the power cable
Warning! If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to avoid
hazard.
AIR VENT
(for the suction versions)
Connect the hood and discharge holes on the walls with a diameter equivalent to
the air outlet (connection flange).
Using the tubes and discharge holes on walls with smaller dimensions will cause
a diminution of the suction performance and a drastic increase in noise.
Any responsibility in the matter is therefore declined.
! Use a duct of the minimum indispensable length.
! Use a duct with as few elbows as possible (maximum elbow angle: 90°).
! Avoid drastic changes in the duct cross-section.
For this product, the rear output use is PROHIBITED for the countries
within the European Community, the EFTA countries, Turkey and all the
countries subject to the Directives EU 65/2014 and EU 66/2014.
! The company declines any responsibility whenever these regulations are
not respected.