Publicité
Les langues disponibles
Les langues disponibles
The inverter will automatically shut down in the event of an output overload so
there is no danger of damaging either the inverter or the equipment. When the
red LED indicator is lit, the inverter is signaling a fault.
Maximum Power from Vehicle Accessory Sockets
Most vehicle accessory sockets that are controlled through a vehicle's ignition
switch are fused at 15 amps. This limits inverter output to approximately 180
watts.
To Power 200 Watt Appliances:
1. For temporary use, connect a battery clip adapter cord (not included) to
the inverter and follow the procedure located under the "Connecting the
Inverter" section.
2. Install a separate fused DC accessory socket wired to the vehicle's battery.
Fuse this circuit at 20 amps.
There is no danger in leaving the inverter directly wired to the battery if the
inverter is turned OFF after each use. The inverter will shut off when the vehicle's
battery level drops down to 9.5 volts to protect the battery from draining
completely.
DETERMINING MAXIMUM APPLIANCE WATTAGE
Do not exceed the 200 watt maximum AC load or the inverter will shut down.
Most electrical tools, appliances, and audio/video equipment have labels that
list the unit's power requirements in watts. If the tool or device is rated in amps,
multiply the amps by 120 (120V AC) to determine the watts. For example, an
appliance rated at 0.5 amps will draw 60 watts.
Remember to consider the startup surge that motorized appliances will cause. Do
not exceed the 400 watt momentary surge rating of this inverter. This can cause
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
WATTS = VOLTS × AMPS
©2015 Wagan Corporation. All Rights Reserved.
6
Publicité
