Wagan Tech Elite 200W PRO Guide D'utilisation page 10

Elite™ 200W PRO by Wagan Tech
TROUBLESHOOTING
PROBLEM: Low or No Output Voltage – Fault LED Lit
Reason
Poor contact with battery, inverter
terminals, or DC socket.
PROBLEM: No Output Voltage – No LEDs Lit
Reason
Blown fuse.
PROBLEM: Inverter Auto Shut Down – Fault LED Lit
Reason
Battery voltage is below 9.5 volts.
Inverter is too hot (thermal shut down
mode).
PROBLEM: Inverter Shut Down – Fault LED Lit
Reason
Equipment being operated draws too
much power.
9
®
Solution
Clean terminals thoroughly. Reinstall
and tighten. Clean DC socket with non-
metallic abrasive emery stick.
Solution
Check vehicle's Accessory Socket Fuse.
If the fuse is blown, replace with the
same type and rating fuse.
Solution
Charge or replace battery.
• Allow inverter to cool.
• Check for adequate ventilation.
• Reduce the load on the inverter to
the specified TrueRated
max output.
Solution
Do not use the equipment with this
inverter; use a higher wattage inverter.
www.wagan.com
power
™