Hkoenig KOL7012 Manuel D'utilisation page 7

number by 0.5 second interval, temperature setting range is 16～30℃/60～86℉。
C. Touch and
degrees. （℃←→℉ transition）.
D. Touch or in TIMER status to adjust time setting.
5) ： touch this key to change fan running speed to High speed 、Medium speed or
Low speed.
。
A. Under COOL
order,
B. Under HEAT
2 minutes.
C. Under TRY mode, fan will be forced to run at low speed , temperature can't be
adjusted.
D. Fan speed will be unchanged if unit operated between COOL and Fan modes, that
means if fan running at low speed under FAN mode, the fan speed will keep same when
unit changed to COOL mode; if fan running at high speed under COOL mode, it would
keep same when unit changed to FAN mode.
E. Fan will be forced running at low speed under Dehumidify and Sleep modes and fan
speed can't be adjusted.
6) ： Touch this key to set unit auto turn-on /turn-off time, to check or cancel time
setting.
A. This unit is designed with 24-hour timer,
last two digits are for minutes 00-60. You can increase or decrease half an hour each
time by touching
B. You can set unit AUTO OFF time when it is running. Or set unit AUTO ON time when
unit is standby. Once timer setting is OK,
over and
C. You can touch
to the final time setting. And TIMER would be ineffective and
any operation from control panel or remote control to turn on or turn off the unit.
+ ： Start SLEEP Function by touching
together in same time to convert Celsius degrees and Fahrenheit
and FAN modes, fan running speed can be adjusted by below
mode, upper fan will run at low speed
or to finish hour and minute setting.
will be off.
again to re-set time when TIMER function is on. The TIMER is subject
after the compressor works
first two digits are for hours 00-24, and
will be lighting till the time you set is
+ in the same time under COOL
would be off if