Door Removal, Leveling, And Alignment - Whirlpool W11159298A Instructions D'installation

Gather the required tools and parts and read all instructions before starting installation. Save these instructions for future reference.
NOTE: Before moving your product into your home, measure the doorway of your home to see whether you need to remove the
refrigerator and freezer doors. If door removal is necessary, see the instructions below.
IMPORTANT: Before you begin, unplug refrigerator or disconnect power. Remove food, the ice storage bin (on some models), and any
adjustable door or utility bins from doors.
TOOLS NEEDED: Bubble level; flat-blade screwdriver; 5/16" and 11/16" wrench; 1/4", 3/8", and 5/16" hex-head socket wrenches,
Phillips screwdriver tip #2 with 4" long as minimum, TORX T30
Disconnect power before removing doors.
Failure to do so can result in death or electrical shock.
Top Left Hinge
6
A
Do not remove A screws
5
Wiring
A B
A. Wiring plugs
B. Wiring clip
C. Grommets
Water Dispenser
4
Tubing
A
A
A. Face of fitting
3
Base Grille
A. Pull to the right for extraction
B. Twist and pass underneath door
† TORX and T30 are trademarks of Acument Intellectual Properties, LLC.
4

Door Removal, Leveling, and Alignment

Door Removal
7
Full Refrigerator
1
C
Freezer
Water
door
filter door
Adjustable front wheels
Water Filter Door and Base Grille
2
screwdriver.
†
WARNING
Electrical Shock Hazard
Top Right Hinge
8
A
Do not remove A screws
Cabinet
Refrigerator
Base
door
grille
Phillips screws
Pull toward you.
Left and Right Bottom Hinge
9
Do not remove B screws
Leveling screws
10
Lower
Raise
Locking Nut
11
Loosen
Alignment Screw
12
Lower
5/16"
wrench
Raise
Lower
11/16"
wrench
Tighten
Raise