Cup Holders - Britax HIGHPOINT Guide De L'utilisateur

Britax Child Safety, Inc.
2� Adjust the SecureGuard Webbing�
• To Shorten: Feed the webbing through the SecureGuard
adjuster and pull the end of the SecureGuard adjuster
webbing to tighten�
• To Lengthen: Feed the end of the SecureGuard adjuster
webbing through the SecureGuard adjuster and pull the
webbing to remove slack from the SecureGuard adjuster�
Then, move the SecureGuard clip to the center of the
SecureGuard webbing�
NOTE: The lower edge of the SecureGuard clip should be
level with the child's upper thighs once the child has been
secured in the booster seat.
3� Reattach the SecureGuard Clip back into the base of the seat
by rotating the adjuster 90 degrees and inserting it into the slot�
Ensure the SecureGuard strap is not twisted�
12

Cup Holders

Installing the Cup Holders
IMPORTANT: DO NOT use cup holders with hot liquids�
1� Slide the cup holder into the booster base and press down until
a click is heard�
NOTE: The cup holders are labeled "L" and "R", from the
position of the child occupant, and can only be installed as
indicated.
Removing the Cup Holders
1� From under the booster base, locate the tab on the bottom of
the cup holder�
2� Pull forward on the tab to disengage the cup holder, then
remove it from the booster base�
NOTE: Cup holders are dishwasher safe.
HIGHPOINT User Guide
13