Connections - Denon AVR-1403 Mode D'emploi

8 CONNECTIONS

• Do not plug in the power cord until all connections have been
completed.
• Be sure to connect the left and right channels properly (left with
left, right with right).
• Insert the plugs securely. Incomplete connections will result in
the generation of noise.
• Use the AC OUTLET for audio equipment only. Do not use
it for hair driers, etc.
Connecting the audio components
Decoders with 6-channel
analog outputs, etc.
LINE OUT
LINE IN
LINE OUT
Tape deck or CD recorder
R L R L
R L R L
INPUT OUTPUT
Connecting a tape deck
Connections for recording:
Connect the tape deck's recording input jacks (LINE IN or
REC) to this unit's tape recording (OUT) jacks using pin plug
cords.
Connections for playback:
Connect the tape deck's playback output jacks (LINE OUT or
PB) to this unit's tape playback (IN) jacks using pin plug cords.
CD recorder, MD recorder or other component
equipped with digital output lacks.
OPTICAL
B
OUTPUT
DIGITAL jacks
Use these for connections to audio equipment with digital output. Refer
to Page 20 for instructions on setting this terminal.
• Use 75 Ω/ohms cable pin cords (sold separately) for coaxial
connections.
• Use optical cables (sold separately) for optical connections.
R L
R L R L
LINE OUT
• Note that binding pin plug cords together with power cords or
placing them near a power transformer will result in generating
hum or other noise.
• Noise or humming may be generated if a connected audio
equipment is used independently without turning the power
of this unit on. If this happens, turn on the power of the this
unit.
Subwoofer jack
Connect the internal amplifier's subwoofer to the subwoofer
terminal. (Refer to page 13.)
Connecting the AC OUTLET
AC OUTLET
• SWITCHED
(total capacity – 120 W (1 A.))
The power to this outlet is turned on and off in conjunction with the
POWER switch on the main unit, and when the power is switched
between on and standby from the remote control unit.
No power is supplied from this outlet when this unit's power is at
standby. Never connect equipment whose total capacity is above 120
W (1 A.)
NOTE:
Only use the AC OUTLET for audio equipment. Never use it for hair
driers, TVs or other electrical appliances.
CD player
OUTPUT
R L
DIGITAL AUDIO DIGITAL AUDIO
R L
ENGLISH
AC CORD
AC 120V, 60Hz
Connecting a CD player
Connect the CD player's analog
output jacks (ANALOG OUTPUT) to
this unit's CD jacks using pin plug
cords.
9