Important Safety Instructions; Installation Instructions; Before Using The Wine Cellar; Installation Of The Wine Cellar - Cavavin C-050WDZ-V4 Manuel D'instruction

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT SAFETY INSTRUCTIONS

WARNING
Read all instructions before using the wine cellar.
DANGER or WARNING: Risk of child entrapment.
Child entrapment and suffocation are not problems of the past. Junked or abandoned
appliances are still dangerous.
Before you throw away your old wine cellar, take off the door but leave the shelves in place so
that children may not easily climb inside.
Never allow children to operate, play with, or crawl inside the appliance.
Never clean appliance parts with flammable fluids. The fumes can create a fire hazard or
explosion.
Do not store or use gasoline or any other flammable vapours and liquids in the vicinity of this
or any other appliance. The fumes can create a fire hazard or explosion.

Before Using the Wine Cellar

− Remove the exterior and interior packing.
− Check to be sure you have all of the following parts:
o
6 shelves (5 large shelves and 1 bottom shelf)
o
2 Keys
o
Stainless Steel Handle
o
Instruction Manual
o
Registration card
− Before connecting the Wine Cellar to the power source, let it stand upright for approximately
twenty four (24) hours. This will reduce the possibility of a malfunction in the cooling system
from handling during transportation.
− Clean the interior surface with lukewarm water using a soft cloth.
− Install the handle on the left side of the door.

Installation of the Wine Cellar

This appliance is designed to be for free standing installation or built-in (fully recessed). Place your
wine cellar on a floor that is strong enough to support it when it is fully loaded. To level the wine
cellar, adjust the front levelling legs at the bottom of the unit.
Locate the wine cellar away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly.
Don't install in a location where the temperature will fall below 60ºF (16ºC). Avoid locating the unit
in moist areas.
For built-in installation, leave a ¼'' (6 mm) space on each side and at the top of the wine cellar to
ensure proper air circulation to cool the compressor and condenser. Also, be sure to not obstruct
the front exhaust vent with any objects as this may affect the unit from performing properly.
For best performance, it is recommended that you install the appliance in a location with an
ambient temperature between 72º-78ºF. If the ambient temperature is above or below
recommended temperatures, the performance of the unit may be affected.
To reduce the risk of fire, electrical shock, or injury when
using your appliance, follow these basic precautions:
-Save these instructions-

INSTALLATION INSTRUCTIONS

23

Publicité

Chapitres

Table des Matières
loading

Table des Matières